2/10/2024 0 Comments Fort Firewall 3.9. instal the newExamples of this are in stadiums where 1 AP is designed to cover a section and an event center where there is high user count per sqft. This antenna is ideal for warehouses.Ī stadium patch antenna is ideal for a high density AP design with expected high user per sqft. Patch antennas are ideal for Access points mounted on a high ceiling and is intended to cover a large space. This antenna is ideal for exterior building use but may also be used for some mesh network designs. Sector antennas are ideal for building mounts as they target the signal away from the interior spaces of the building and focus the energy to the larger outdoor space. Use omni directional antennas when designing to cover 360 degrees around the Access Point. Omni directional antennas are best for pole mounts applications and for mesh networks. It is always best practice to consult with a Cisco SE or Partner in to select the best antenna for the unique design. Below is a highlight of the different antenna types and their applications. The MR74 features band-specific antenna ports, and thus the corresponding band-tuned antennas should be paired with the AP. Meraki offers a number of antenna options for the MR74 access point. If necessary, reconnect the AP to the LAN.Configure the static IP address, net mask, gateway IP address and DNS servers that this AP will use on its wired connection.Qxxx-xxxx-xxxx), with no password (e.g., Q2DD-551C-ZYW3). The default login is the serial number (e.g. Click on the “Uplink Configuration” tab.Using a web browser on the client machine, access the AP’s built-in web server by browsing to.If using a PoE Injector, connect the MR74 to the “PoE” port of the Injector, and the client machine to the “LAN” port. Then connect the client machine over Ethernet cable to the PoE switch. If using a PoE switch, plug an Ethernet cable into the MR74’s Ethernet jack, and the other end into a PoE switch. If using a wired connection, connect the client machine to the MR74 either through a PoE switch or a PoE Injector.Using a client machine (e.g., a laptop), connect to the AP wirelessly (by associating to any SSID broadcast by the AP) or over a wired connection. The following procedure describes how to set the static IP: Static IPs are assigned using the local web server on each AP.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |